Volkswagen CarPlay/Android Auto Retrofit – Reverse Camera Guide (SKU: BA-VW-MMI1)

For Volkswagen Wireless CarPlay & Android Auto Interfaces
SKU: BA-VW-MMI1

---

Our retrofit kits support both OEM cameras and aftermarket cameras. Correct configuration depends on your vehicle and installation type.

---

OEM Factory Camera

• Go to Settings → Reverse → Camera → Original.
• Set Reverse Wire to OFF.
• Guidelines and radar will display as per the OEM system.
• Keep all other reverse settings at default.

---

Aftermarket Camera – Automatic Transmission

• Connect the reverse camera to the CVBS port labelled “Reversing Camera”.
• Connect the yellow cable labelled “12V Reverse Camera” to the camera power supply.
• Go to Settings → Reverse → Camera → Aftermarket.
• Set Reverse Wire to ON.
• Leave Guidelines/Radar OFF unless the camera itself has built-in support.

---

Aftermarket Camera – Manual Transmission

• Connect the reverse camera to the CVBS port labelled “Reversing Camera”.
• Connect the purple wire labelled “Reversing Detection 12V” to the reverse light.
• Go to Settings → Reverse → Camera → Aftermarket.
• Set Reverse Wire to ON.
• Enable the following: • Reverse Line – ON • Reverse Track – ON • Reverse Radar – ON

⚠️ Note about Flickering (Manual Cars)

• On some vehicles, the reverse light circuit is controlled by CANBUS.
• CANBUS often sends a pulsed voltage signal to monitor bulb condition.
• When connected directly, this pulsing can cause the camera image to flicker, roll, or cut out, especially when the engine is running.

Solution:

• Install a flicker filter (CANBUS stabiliser) or a relay.
• The relay allows the reverse light circuit to act only as a trigger, while the camera is powered from a stable 12V feed (e.g. ignition or accessory).
• This ensures the camera receives a constant, clean voltage → stable image with no flicker.

---

Extra Settings

• Reverse Option Delay: Adjust camera display time (0–15 seconds).
• Front Camera Mirror / Rear Camera Mirror: Toggle ON/OFF as needed.
• Radar Options: Ensure Reverse Radar ON if using OEM sensors.

📄 For wiring diagrams, refer to the installation PDF supplied with the kit.